Installation Guide

Home / Interior / Dash Mounts / Wolfbox Mounting Kit for INEOS Grenadier by Agile Offroad Installation Guide

Wolfbox Mounting Kit for Grenadier by Agile Offroad

SKU: G18-1005

Installation Manual PDF Download Additional Information

Installation Manual

A billet aluminum mounting solution designed to securely mount the Wolfbox rearview mirror to the factory mirror mounting point on the INEOS Grenadier. Built to eliminate movement caused by the heavier Wolfbox mirror during off-road use.

SKU: G18-1005

PARTS INCLUDED

  • 1 x AO Wolfbox Mirror Mounting Bracket (Wolfbox Mirror Sold Separately)
  • 1 x Ball Mount Wrench

TOOL NEEDED

  • #1 Phillips Screwdriver
  • Clip Remove Tool

INSTALLATION TIME: 20 Minutes

Installation Steps

1

Remove the four rubber pads on back of Wolfbox mirror.

2

Use a #1 Phillips screwdriver to remove the four mirror tab screws.

3

Remove the four tabs.

4

Install the AO Mirror Bracket adapter as shown using the previously removed screws.

5

Remove the ball mount nut.

6 A/B

Use a clip removal tool to remove the outer c-clip from the factory installed mirror. The factory mirror has a small slot on the upper driver side to aid in the removal of c-clip.

7

With c-clip removed, pull straight back on mirror.

8

Install AO Mirror Bracket Adapter ball mount nut.

9

Install the mirror assembly onto the factory ball mount.

10

Screw on the ball nut.

11

Use the supplied wrench to fully tighten ball nut.

12

Adjust mirror as desired. Use the Wolfbox supplied instructions for wiring instructions.