Installation Guide

Home / Electrical / Power System Upgrades / LUXLOCK Lighted Ignition Keyhole Upgrade for INEOS Grenadier by Agile Offroad Installation Guide

LUXLOCK Lighted Ignition Keyhole Upgrade for INEOS Grenadier by Agile Offroad

SKU: G18-1006

Installation Manual PDF Download Video Additional Information

Installation Manual

The LUXLOCK™ Lighted Ignition Keyhole Upgrade adds a clean, factory-style illumination to the Grenadier’s ignition switch, making it easy to locate the keyhole in low-light conditions.

SKU: G18-1006

PARTS INCLUDED

1 x AO LuxLock Ignition Keyhole Upgrade

TOOL NEEDED

T20 Torx Bit
T25 Torx Bit
T30 Torx Bit
1/8” Tip Screwdriver

INSTALLATION TIME: 30 Minutes

Installation Steps

Partially remove the driver side weatherstrip closest to the steering wheel.

Remove the corner dash panel. Use a T20 Torx bit to remove the two left side center dash panel screws.

3 A/B

Use a T20 Torx bit to remove the two lower panel screws. Remove the lower panel.

Use a T20 Torx bit to remove the three lower screws of the center panel. Remove center panel.

5 A/B

Use a T25 Torx bit to remove the three ignition screws.

6 A/B

Locate the small groove opening at the bottom of the ignition ring. Use an 1/8” tip screwdriver to start separating the factory ignition ring from the ignition switch.

To avoid damaging the ignition switch, keep screwdriver tip in plastic groove only.

Gently separate the ring from the face of the ignition switch. Avoid any contact with exposed copper wire.

Hinge open the ignition ring and then unclip from the top of ignition switch.

Route the AO LuxLock Ignition Keyhole harness in the hole behind the ignition.

Continue routing the harness to the fuse block below ignition.

Starting from the bottom of the switch, install the AO LuxLock Ignition Keyhole onto the ignition switch.

13 A/B

Clip the top wire channel onto the ignition switch.

Re-install the ignition assembly using the factory screws.

Use a T30 Torx bit to install the harness ground ring to the screw located behind the bottom corner of the fuse block.

16 A/B

Remove the lower driver side 5-amp fuse and install the harness piggyback fuse holder. Install the removed fuse into the empty slot of the piggyback fuse holder.