Installation Guide

Home / Exterior / Engine Bay Accessories / Hood EZ Grab Tab for Sprinter by Agile Offroad Installation Guide

Hood EZ Grab Tab for Sprinter by Agile Offroad

SKU: AO-E3S-1

Installation Manual PDF Download Additional Information

Installation Manual

Can only be used with vans equipped with hood struts.

SKU: AO-E3S-1

PARTS INCLUDED

  • 1 x AO Strap
  • 1 x Conical Washer
  • 1 x Flat Head Bolt
  • 1 x Rivet Nut w/Installation Tool

TOOL NEEDED

  • 9⁄16” Open Wrench
  • 3mm Allen Wrench
  • 4mm Allen Wrench

INSTALLATION TIME: 20-30 minutes

Installation Steps

1

Fully open the hood and locate the factory hole to the right of the hood latch.

2

Insert the supplied Rivet nut and installation tool assembly into the factory hole. Use a 9/16” wrench to hold the installation nut and a 4mm Allen wrench to tighten the center bolt. Tightening the center bolt causes the Rivet nut to crimp on the hood sheet metal.

3

Tighten center bolt approx. 3.5 turns until the Rivet nut is fully collapsed. DO NOT OVER-TIGHTEN.

4

Ensure the Rivet nut is fully collapsed.

5

Use a 3mm Allen wrench to install the AO Hood Strap using the supplied flat head bolt and conical washer.

6

Align the AO Hood Strap as shown. Torque bolt to 16 inch-lbs.