Installation Guide

Home / Suspension / Shocks / Fox 2.0 Rear Shocks for Sprinter 3500 4x4 by Agile Offroad Installation Guide

Fox 2.0 Rear Shocks for Sprinter 3500 4x4 by Agile Offroad

SKU: AOR115

Installation Manual PDF Download Additional Information

Installation Manual

Required Tools:

  • Jack stands
  • Floor jack
  • 21 mm socket & wrench
  • Torque wrench
  • Thread-locker (red)

Installation Steps

1

Lift vehicle and support vehicle with jack stands using factory jack points. Remove the rear wheels.

2

Remove old shocks starting with the lower bolt. Discard the shocks. Save factory hardware, you’ll reuse it.

3

Clean the factory hardware. The included washers are to be installed between the shock body & the frame rail.

4

Install new shocks (boot-side down) and shock bolts on the inside of the frame rail.

5

Apply thread-locker and install the upper shock hardware.

6

Use a jack to compress the shock. Line up the lower shock mount holes on the axle with the shock and install the shock bolt.

7

Apply thread-locker and install the lower shock hardware.

8

Torque upper shock bolt to 110 ft-Lbs.

Torque lower shock bolt to 110 ft-Lbs.

Reinstall wheels & torque lugs.

Steel wheels 140 ft-Lbs.

Alloy wheels 125 ft-Lbs.